ADMIN Re: List setup

Subject: ADMIN Re: List setup
From: "Lisa M. Bronson" <lisa -at- techwr-l -dot- com>
To: "Dick Margulis" <margulisd -at- comcast -dot- net>
Date: Wed, 19 Jul 2006 09:13:15 -0500

Good morning, everyone. :)

What Dick says is one reason why the list is set up the way it is. I used to
be on a neighborhood association list, and watched some friends of mine have
a marital spat on the list. I wrote and told her what was happening, but not
before they had exchanged several emails.

There are other reasons this list is set up as it is, as well, not the least
of which is the amount of list traffic. When list membership gets as large
as TECHWR-L (currently over 2,600 subscribers), every message has an impact
on the system and on it's subscribers. I receive enough complaints about
the signal-to-noise ratio of the list as it is! (Yes, that's a subtle
reminder to be careful in what you post.) And Mailman, our list processing
software "_strongly_ recommends" (emphasis theirs) that replies go to the
poster, not to the list.

If you have anything further to say on this subject, please write to me
directly, off-list. Simply hit Reply, not Reply All. :)

Warm regards,

Lisa B.
TECHWR-L Administrator



On 7/19/06, Dick Margulis <margulisd -at- comcast -dot- net> wrote:


John Cornellier wrote:
> Lots of people send messages to the poster rather than the group. This
> is because of the way the email is set up. Perhaps this "feature" is
> more of a "bug"? The default behaviour is to reply to the original
> sender, which to me at least is counter-intuitive.
>
>

John,

I participate on two lists where the default behavior is to reply to the
list and you have to manually delete the list address and copy/paste the
member's address if you want to reply privately.

This arrangement leads to FREQUENT embarrassment for people who intended
to write privately to the OP.

The setup on techwr-l, where Reply All is the way to post to the list,
is far preferable IMO.

Dick
http://ampersandvirgule.blogspot.com/


^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^

WebWorks ePublisher Pro for Word features support for every major Help
format plus PDF, HTML and more. Flexible, precise, and efficient content delivery. Try it today!. http://www.webworks.com/techwr-l
Doc-To-Help includes a one-click RoboHelp project converter. It's that easy. Watch the demo at http://www.DocToHelp.com/TechwrlList

---
You are currently subscribed to TECHWR-L as archive -at- infoinfocus -dot- com -dot-
To unsubscribe send a blank email to techwr-l-unsubscribe -at- lists -dot- techwr-l -dot- com
or visit http://lists.techwr-l.com/mailman/options/techwr-l/archive%40infoinfocus.com


To subscribe, send a blank email to techwr-l-join -at- lists -dot- techwr-l -dot- com

Send administrative questions to lisa -at- techwr-l -dot- com -dot- Visit
http://www.techwr-l.com/techwhirl/ for more resources and info.


Previous by Author: II am no longer employed at Jeppesen.
Next by Author: ADMIN Re: A digest that consists of subject headings
Previous by Thread: RE: Frame question: forcing a page to the right side
Next by Thread: Does this job exist?


What this post helpful? Share it with friends and colleagues:

Sponsored Ads


Sponsored Ads