TechWhirl (TECHWR-L) is a resource for technical writing and technical communications professionals of all experience levels and in all industries to share their experiences and acquire information.
For two decades, technical communicators have turned to TechWhirl to ask and answer questions about the always-changing world of technical communications, such as tools, skills, career paths, methodologies, and emerging industries. The TechWhirl Archives and magazine, created for, by and about technical writers, offer a wealth of knowledge to everyone with an interest in any aspect of technical communications.
>I tried to save Frame 4 files to .rtf and import to Word 6 and it was
>genuinely messy. Text on the master pages was intermingled throughout.
>I haven't tried the same maneuver with Frame 5 and Word 7, so I dunno.
>I'm guessing it can be done--but not without tinkering with the source
>a bit beforehand.
I recently imported some Frame 4 files to .rtf using Frame 5. I then
opened the files with Word 6.0. The only problem I had was with some
of the text formatting. Other than that, it went off without a hitch.
Bill Burns
Assembly Training and Documentation Supervisor
WBURNS -at- MICRON -dot- COM
TECHWR-L List Information
To send a message about technical communication to 2500+ list readers,
E-mail to TECHWR-L -at- LISTSERV -dot- OKSTATE -dot- EDU -dot- Send administrative commands
ALL other questions or problems concerning the list
should go to the listowner, Eric Ray, at ejray -at- ionet -dot- net -dot-
